CCIE Dial/ISP

Practice Lab Practice Examination

*Please note that the exam structures change over
time. Please consult
www.cisco.com
CCIE Certifications for
updated information.
Network Diagram


Lab III. IP Configure the network using network 130.10.x.x
• Use an 8 bit subnet mask unless otherwise specified At the end of each exercise, verify connectivity between all ports:
• All IP routes appearing in all routers
• Ping from any interface to any other interface

Section 3A ISDN and Analog Connectivity1. Configure the 800 so that it dials R2 and R3 if interesting traffic
Is seen.
2. Configure R2 and R3 so that it will terminate Analog modem calls.
3. Configure R1, R2 and R3 so that R1 will terminate all ISDN calls.
4. Configure the lab computer so that it will dial and connect up to either
R2 or R3. It must receive a valid IP address from the Access Server.

Section 3B Authentication1. Configure R1, R2 and R3 so that it will use the CiscoSecure Server-NT Tacacs+
database to authenticate all PPP connections.
2. Create a Username on the ACS server called ccie_user with password cisco.

Section 5A1. Configure the Aux port on R4 and R5 for modem access.
Configure R4 such that if interesting traffic is seen it will dial R5. All routes should still
be seen on all routers. Lab VI. VPDN and Security
Section 6A
1. Configure R5 and R6 such that when a call is received from R4 it is
Forwarded from R5 to R7. Use the name

to create
The tunnel.
Section 6B

1. Configure the PIX such that it will allow all traffic to flow from the inside