1
ME-430 Introduction to Computer Aided Design
SHAFT -
Pro/ENGINEER Wildfire 2.0
Dr. Herli Surjanhata

From File pull down menu, select Set
Working Directory.

Select Working Directory dialog
box appears, and change to
appropriate working directory (e.g.
J:\ME-430\Shaft) 2
3In the dashboard, click
.

Click Define.
Pick FRONT datum plane as Sketch
Plane.

Accept default Sketch Orientation
Reference.

Then click the Sketch button
. 4

5

Click
to re-dimension as shown below.

Click
to modify the dimensions so that the final dimensions is
shown in the figure below.

Note that diametrical dimensions in four places. To get diametrical dimension do the
following:

• Left-click the line, left-click the centerline, and again left-click the line.
• Bring the cursor where you want to locate the dimension, then middle-click
that position.

Constraint:
Symmetry with
respect to vertical
centerline -

Constraint: Line
up horizontal -


CREATE A KEYWAY
Pick the Extrude Tool icon
. Click the Remove Material icon
.

Select the Extrude on both sides
icon
.

Enter the cut depth 0.1875 in.

Click
, then select
to sketch section
for cut.
Pick FRONT as sketching plane, accept default and click Sketch button.

Create the base feature – Pick the Revolve Tool icon
.
10

In the dashboard, click the
Remove Material icon
.
Click
, then select
to sketch
section for cut.
Pick FRONT as sketching plane, accept default and click Sketch button.