2002. 3.
2002. 3.
Technical Service Training Center
Technical Service Training Center
New Model Service Training
VEHICLE : TB(Gets)
- 2 -
Chonan TSTC
Newly Adapted Item in the Body Electrical other parts when compare with
New ACCENT.

ETACS section
- Power window timer
- Crash door unlock control from A/BAG
- Battery Saver Control(Tail Lamp Auto Cut Control)
- One button in-key type transmitter
- Using B/Alarm horn instead of siren & receive antenna built in ETACSCM
- Key Code Saving Use by Hi-scan

Body Electrical section
- In-Panel Junction Box
- Head Lamp Circuit Relay-less type
- Front Wiper Motor Control Relay-less type
- One Cooling Fan Motor type
- Body-less Multi function switch


Body Electrical System section
- Trip Computer

Electrical General

Kind different function compare.
- 5 -
Chonan TSTC
Power Window Timer Control
Power Window Timer Control Time Chart
IGN. S/W
Driver’s or Assist
DR S/W
POWER
WINDOW MOT.
ON
OFF
OPEN
CLOSE
ON
OFF
* T1 : 30 ± 3 sec.
Power Window Off
T1
T1
Description
1. Power window output is “ON”, when IG. switch is turned “ON”.
2. Power window output should be OFF after maintaining ON for 30 seconds, when IG. switch is
turned OFF.
3. If the driver door or front passenger door is opened within 30 seconds, the power window output
must be off.
Remained time
- 6 -
Chonan TSTC
Crash Door Unlock Control

Chonan TSTC
Battery Saver Control
Description
1. In case of the tail lamp switch is turned ON after IG. SW ON or the driver door
is opened after IG. SW OFF, the tail lamp is extinguished automatically.
2. In addition, the IG. SW is turned OFF after driver door is opened with IG. SW is ON
condition, the tail lamp will be extinguished automatically too.
3. After automatic extinguish, if the tail lamp switch is turned ON again,
then, the tail lamp will be ON (illuminating) and the auto cut function will be released.
IG. KEY
Switch
Inserted
Removed
ON
OFF
OPEN
CLOSE
TAIL LAMP
SWITCH
Driver’s Door
Switch
Lamp Auto Off
TAIL LAMP
(REALY)
ON
OFF
Lamp Auto Off
Battery Saver Control Time Chart(Tail Lamp Auto Cut)
- 8 -
Chonan TSTC

Room Decay Out Control
Room Lamp control after receive “Keyless Unlock or Lock” signal.
Description
1. The room lamp prolongs light “ON” about 30 sec. If the Transmitter unlock signal
receive with door is closed.
2. During room lamp operating by unlock signal of the Transmitter, lamp light goes OFF immediately
if receive ignition switch ON or lock signal of the Transmitter.
3. The room lamp keeps lighting “ON” in light “ON” when opening the door, the room
lamp is back to the delay function.
FRT LH or RH
Door S/W
Opened
Closed
Transmitter
T1
Room Lamp
UNLOCK
LOCK
ON
OFF
* T1 : 30 ± 2 esc. * T2 : 5.5 ± 0.5 sec.
T2
- 10 -
Chonan TSTC
Burglar Alarm Horn
1. Using Burglar Alarm Horn instead of Siren
2. Keyless Receive Antenna Built in the ETACS CM
3. Transmitter One Button type in Key
4. Door's Lock and unlock by ONE BUTTON that is combined with Ignition key.
ETACS CM

Receiver
Location
Code Saving Tool
ICM Location
Code Saving Method
OFF/SET
S/W
Hi-scan Immobilizer
Non
Immobilizer
RCT
ground
Accent(LC) In ETACSCM O X In ECM Method 1 Method 1
Elantra XD In ETACSCM O O In ECM Method 1 Method 1
Metrix(FC) In ETACSCM O O In ECM Method 1 Method 1
EF Sonata
Out side of
ETACSCM
O X ETACS RX. Method 2 Method 1 O
New EF
Out side of
ETACSCM
O O ETACS RX Method 2 Method 1
XG In ETACSCM O O In ECM Method 1 Method 1 O
Traget XG In ETACSCM O X In ECM Method 1 Method 1
Santa-Fe In ETACSCM O X In ECM Method 1 Method 1
Atoz
Out side of
ETACSCM
O X In ECM Method 2 Method 2

4.Move the “OFF/SET” switch to “OFF” position again.
OFF
SET
1
OFF SET
2
OFF
SET
4
Lock / Unlock Button
3
- 15 -
Chonan TSTC
Code Saving Method 2 immobilizer
.
2.Move the “OFF/SET” switch to “SET” position.
◐ OFF/SET switch is on “OFF” position at first
3. Push “Lock & Unlock” button of the
transmitter at the same time while 1sec.
and Lock or Unlock push once again while
1sec. If make to code save two transmitter
have do finish within 10seconds from
moved OFF/SET switch.
OFF SET
2
OFF
SET
4
4.Move the “OFF/SET” switch to “OFF”
position again

transmitter have do finish within 10seconds
from moved OFF/SET switch.
.
OFF SET
1
OFF
SET
3
3.Move the “OFF/SET” switch to “OFF”
position again
Off/Set switch
Antenna
Off
Set
Lock/Unlock Button
2
- 17 -
Chonan TSTC
IN-Panel Junction Box
Adapted IN-Panel Junction Box
IN-Panel Junction Box
FUSE & Relay Box
Fuse & Relay Box Back side
IN-Panel Junction Box
Circuit Board
New
ACCENT
Fuse
&
Relay Box