PREPARING THE SHAFT
FOR DETAILED DRAWING
1
ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN
SHAFT DETAILED DRAWING
Pro/ENGINEER Wildfire 2.0
Dr. Herli Surjanhata

PREPARING THE SHAFT FOR DETAILED DRAWING

Open shaft.prt, and make sure you have the saved view ISO_1.

Create A Cosmetic Curve And An Axis Through The Curve Portion Of
The Keyway
From Insert pull down menu, select


Click
.
Create An Axis Thru The End Of Keyway
Click
, and pick the curved
end of the sledrunner keyway. 4

Click
to insert drawing view of the
shaft.
The message prompt to Select CENTER POINT fro drawing view, and pick a
location near the middle left of the drawing – see Figure. The Drawing View dialog
box opens.
Under Model view
names, select
FRONT from the
list.

Click OK.

Turn off the
datums and
coordinate system.

,
and click
to
redraw.
Create A Projected TOP View Of The Shaft
7

Click the FRONT view, then
right-click and select Insert
Projection View.

Pick a location to the top of the
front view. Create A Scaled ISOMETRIC View Of The Shaft

Click
to insert
drawing view of the
Create A Detailed View Of Snap Ring Groove
9From Insert pull-down menu,
select

Drawing View -> Detailed. Pick a point on the top view in the center
of the snap ring groove.



11Pick the front, top and
detailed views, make
sure it is boxed in red.

Right-click, and select
Properties.

Un-check Use
present view style.

Select Hidden for
Display style.

OK. 12Pick the right and

Verify that the Show button is selected.
Click the dimension button
.

Select Feature and View in the Show
By section.
From Show pull down menu in the
Navigator, select Model Tree.

14

Pick the revolved protrusion in the Model
Tree or front view.
Click OK.


on.

Under Show By, select View.

Pick the front view and click the Accept
All button.

Pick the top view and click the Accept
All button.

Pick the right view and click the Accept
All button.

Pick the detailed view and click the
Accept All button.
Zoom in to the right side view.

Click the Erase button, and Axis button.

Under Erase By, select Selected Items.

Pick the small transverse axis through
the sledrunner keyway to remove it.


The only cosmetic curve remaining is on
the front view.

Close the Show/Erase dialog box. 17
Clean Up the Drawing Dimensions
Click
.

Pick front, top, and detailed
views.

Click OK.
Accept the default offset and increment
values.

Click Apply.

Click Close.

Switch the Diametral Dimensions to the Top View



19Pick Move Text
button
. Move the numerical value of the
dimension to the left.
20Pick the 3.00 keyway length, and move
it to the front view.

Right-click and select Move Item to
View.

Pick the front view.

The result after clean up is shown below.

22
Create a Section View for Dimensioning the Keyway Depth and Width 23Click the front view, then
right-click and choose
Insert Projection View.

Pick a point to the left of
the front view. Turn on
datum plane -
and
repaint the screen -
. Planar -> Single -> Done
Enter A for the cross section name. Select Make Datum -> Offset
Pick the RIGHT datum plane in
the front view.

OK.

Select Enter Value Enter a value of -3.5

Select Done